 BMS Specifications...STANDARD EQUIPMENT
One piece, hot rolled steel slab, gun-drilled for heating
medium.
Laminated aluminum construction incorporates rolled
aluminum plates which contain the heating fluid and cooling medium if required.
Frame
Welded steel frame construction, designed for operating pressures up to
200 p.s.i. (14 kg/cm2). Hinging upper frame is opened hydraulically to angles
up to 85 degrees. Platen widths up to 80 inches (2030 mm). Press lengths up to 48 feet (16
m) in 12 foot (4 m) increments. All press functions are interlocked to provide maximum
operator and product safety. The press frame is manufactured in one piece complete.
Maximum daylight opening between platens is 12 inches (300 mm). Available in down-stroking
or up-stroking configurations.
Pressure System
The unique Almex pressure bag is protected from heat degradation by a
water cooled insulation package. Membrane installations utilize high-temperature
elastometrics for the inflatable member. Pressure system does not include air compressor
or air receiver.
OPTIONAL EQUIPMENT
Edge Irons
A hydraulically actuated edge iron system may be mounted on the front and
rear of the press lower frame. Ideal for materials that become semi-liquefied at elevated
temperatures.
Temperature Chart Recorder
A continuous paper chart recorder provides a permanent record of cure
temperatures.
Platen Cold Ends
For manufacturing continuous products, the heating platens may be equipped
with a water cooled cold zone, eight inches wide (200 mm).
Automation
Press functions can be automated to speed up the cure cycle, and maximize
productivity.
Control systems may be either PC or PLC based. Customized software allows graphic
displays, data acquisition and networking.
Remote Supervisory Stations allow managers and supervisors to interface with the system
from the convenience of their office.
Clamp and Stretcher Units
When it is necessary to pre-tension the elastic product prior to curing, a
mechanical stretcher unit and a clamp unit are positioned at each end of the press. Clamp
and stretcher can be tilted to a maximum of 45 degrees from the horizontal. Uniform
tensioning across the belt width provided by hydraulically driven screw
jacks. Automatic
measurement ensures repeatability.
|
